To clean ice hockey goalie leg pads, start by wiping them down with a damp cloth to remove any surface dirt and debris. Then, mix a solution of mild detergent and water and use a soft brush to gently scrub the pads. After scrubbing, wipe them down with a clean, damp cloth to remove any soap residue. Finally, allow the pads to air dry completely before using them again. It's important to regularly clean and maintain goalie leg pads to ensure they remain in good condition and perform at their best. **

To clean ice hockey goalie skate blades, start by wiping off any excess snow or ice with a towel. Next, use a soft cloth or sponge dampened with warm water to gently wipe down the blades, being careful not to get the boot too wet. Finally, dry the blades thoroughly with a clean towel and store them in a skate guard to prevent rusting. It's important to regularly clean and dry the blades to maintain their sharpness and prevent damage. **

To soften your ice hockey goalie catching glove, you can try using a leather conditioner or glove oil specifically designed for sports equipment. Apply the conditioner or oil to the glove and then gently massage it into the leather, paying extra attention to the areas that feel stiff or rigid. You can also try using a mallet to gently pound the glove in order to break in the leather and make it more flexible. Additionally, using the glove during practice and games will also help to naturally soften the leather over time. **

To connect outdoor lighting, you will first need to plan the layout and design of your lighting system. Next, you will need to run electrical wiring from a power source to each light fixture, making sure to bury the wiring at the appropriate depth and use waterproof connectors. Once the wiring is in place, you can then connect each light fixture to the wiring, following the manufacturer's instructions for installation. Finally, you will need to test the system to ensure that all the lights are working properly and make any necessary adjustments. It's important to follow all local building codes and safety guidelines when connecting outdoor lighting. **

A timer for outdoor lighting works by allowing you to set specific times for your outdoor lights to turn on and off automatically. You can program the timer to turn the lights on at dusk and off at dawn, or set a custom schedule based on your preferences. The timer is typically connected to the outdoor lighting system and controls the flow of electricity to the lights based on the programmed schedule. This helps save energy and ensures that your outdoor lights are only on when needed. **

The outdoor lighting may not be working anymore due to a variety of reasons such as a blown fuse, a tripped circuit breaker, a faulty light bulb, or a problem with the wiring. It is also possible that there is an issue with the timer or the light sensor. It would be best to check each component systematically to identify and address the specific cause of the malfunction. **

To remove custom content, decor, or furniture in Sims 4, you can go to the build/buy mode by clicking on the hammer and wrench icon at the top right corner of the screen. Once in build/buy mode, you can click on the item you want to remove and press the delete key on your keyboard or right-click on the item and select the delete option. If you want to remove custom content, you can go to the game options menu, select the 'Other' tab, and then click on 'Enable Custom Content and Mods' to disable them. **

The outdoor lighting may not be turning on automatically anymore due to a malfunction in the light sensor or timer that controls the automatic function. It could also be caused by a power outage or a tripped circuit breaker disrupting the electrical supply to the lights. Another possibility is that the bulbs in the outdoor lighting fixtures have burned out and need to be replaced. It would be advisable to check these potential issues to determine the cause of the problem and address it accordingly. **